menü simgesi Categories
Actuonix

Actuonix Linear Actuator - L12-100-50-6-R, Control: RC Servo & Arduino Interface, 6V

Product Code : 03.05.005.064
2,983.99 TL + VAT
3,580.79 TL (VAT Included)
  • Features
  • Payment Options
  • Comments (0)
  • Actuonix L12-100-50-6-R, Micro Linear SERVO Actuator - Rod Type, RC & Arduino Interface ( -R ), 6V, 100mm Stroke, 50:1


    Actuonix L12 linear actuator types are divided into four according to the control method; with limit switch (-S), position feedback with potentiometer (-P),  built-in microcontroller (-I) and standard hobby type RC servo motor interface (-R). L12-R series with servo motor control and Arduino interface have the following essential variations;

       o There are 3 different stroke options: 30mm, 50mm and 100mm 

       o There are 3 reduction ratios (25mm/s, 13mm/s, 6.5mm/s no-load speed) that can generate 22N, 42N and 80N max lifting force for different sized loads.

       o With 6V supply voltages there are 9 types of actuators in this series

    Actuonix L12-R servo actuators are preferred in RC model toys (dumper chassis, excavator, dozer, loader, model airplane), retractable awning and sunshade motorization, camera stabilizers (camera gimbals) and different robotic architectures.

    Other highlighted features of Actuonix L12-100-50-6-R linear servo actuator:

    i) The L12-R linear servo motor series can be a direct replacement for standard hobby servos. Whether controlled by an RC receiver, an Arduino microcontroller board or a VEX microcontroller, it acts as an electric piston capable of linear push-pull motion in your project.

    ii) Actuonix L12-R linear servos have 3 connectors (GND, PWR and Control signals) with standard servo connection.

    iii) 12V supply voltage and 10mm stroke options are NOT available on the L12-R series!

    iv) L12-R series consists of anodized aluminium shaft, metal geared DC motor (in black plastic parts), brass screws and steel bearing and control electronics.

    v) The L12-R has plug & play compatibility with many RC receivers. However, it is incompatible with Futuba receivers that output 2.7V, such as the R6014FS. Regulators such as Smart Fly Power Expander or Orbit Power Jack can be used to reduce the signal level to 6V.


    Actuator Types in L12-R Family


    This Product is L12-100-50-6-R :

     L12-100-50-6-R 
    L12 100 50 6 R
    Rod Type  100mm: its stoke length 50:1 gear ratio   6V Nominal supply voltage Control: it has RC hobby servo & Arduino Interface



    Compare this product with others in the L12-R Family:


    Gearing Options

    50:1

    100:1

    210:1





    Stroke

    10mm
    X X X

    30mm




    50mm




    100mm




    L12-R Technical Features




    Gear Ratio 50:1 100:1 210:1
    Peak Power Point 17N @ 14mm/s 31N @ 7mm/s 62N @ 3.2mm/s
    Tepe Efficiency Pointı 10N @ 19mm/s 17N @ 10mm/s 36N @ 4.5mm/s
    Maximum Speed (no-load) 25 mm/s 13 mm/s 6.5 mm/s
    Maximum Force 22N 42N 80N
    Back Drive Force 12N 22N 45N

    Stroke Options

            10mm                   30mm                  50mm                   100mm
    Mass X 34g 40g 56g
    Repeatibility (-I,-R,-P) X ±0.2mm ±0.3mm ±0.5mm
    Maximum Side Load X 40N 30N 15N
    Closed Length X 82mm 102mm 152mm
    Potantiometer (-I,-R,-P) X 3kΩ/mm ± 30% 6 kΩ/mm ± 30% 11 kΩ/mm ± 30%
    Voltage Options 6V
    Maximum Input Voltage  7.5V
    Standby Current  7.2mA
    Stall Current  460mA
    Working Temperature –10°C to +50°C
    Maximum Duty cycle % 20
    Noise 55 dB,  @45 cm 
    Ingress Protection IP-54
    Mechanical Backlash 0.2mm
    Maximum Static Force 200N


    Technical Drawing


    actuonix-L12-boyutlar.jpg (139 KB)

    Links


    L12 Series Actuator Datasheet: Actuonix L12 Datasheet
    L12 Series 3D Model (IGES) 10, 30, 50 and 100mm: L12 3D Models (IGES)
    L12 Series 3D Model (STP): L12 3D Model (STP)

Prepared by  T-Soft E-Commerce.